kaylinpickles 1 Report post Posted December 15, 2011 hi guys, any suggestions on how i can incorporate these two into a tiny 3-room flat toilet? As you know some 3NGs toilets are reallyyyy small, usually 1500x1500mm square so I was wondering besides hacking two toilets to form one, are there any workarounds? Anyone knows if its possible to reposition the toilet bowl and sink? Not sure if HDB will approve or not. Share this post Link to post Share on other sites
albertchng 0 Report post Posted December 16, 2011 hi guys, any suggestions on how i can incorporate these two into a tiny 3-room flat toilet? As you know some 3NGs toilets are reallyyyy small, usually 1500x1500mm square so I was wondering besides hacking two toilets to form one, are there any workarounds? Anyone knows if its possible to reposition the toilet bowl and sink? Not sure if HDB will approve or not.3NG toilet is not small, 3i toilet is really small.You can hack down the wall to extend the toilet, but HDB only allow a maximum of 2 feet (60cm or 600mm) and must only be use as dry area. You can ask HDB if you are allow to reposition the toilet bowl and sink, may need to extend the drainage and waste piping (increase the chances to get choke). Share this post Link to post Share on other sites
ZzzMonster 7 Report post Posted December 20, 2011 When I recently renovate my toilet, my contractor told me cannot relocate toilet bowl... Thus, I leave it alone. I, however, relocate my sink and shower point... Share this post Link to post Share on other sites