berry_surprise 0 Report post Posted June 7, 2010 Hi Berry, i am currently looking for system 4, as my old Daikin is breaking down any time. Going back for Daikin as it has served me well for 14 years. I got a quote from everjoint electrical at $2430. They using armaflex (dunno hw to spell) class 1 insulation and provide no limit piping. And they allowed 2x free installation. Going to scout more before i confirm the deal, ur side any gd deals? $2430 is pretty much a good deal! but what's its their btu? the starmex offers me 1x26kbtu 1x13kbtu 2x10kbtu Share this post Link to post Share on other sites
Bits N Pieces 0 Report post Posted June 8, 2010 Bought a LG Health+ air con with GC during the weekend energy saving roadshow. LG Health+ Air con S$3,449 Extended warranty S$ 399 Upgrade of material S$ 230 2 trips installation S$ 80 Remove of exiting air con with out trade in cost. Promotion: Robinson voucher S$200.00 End up pay a bit here and there end up more than what I expect... Share this post Link to post Share on other sites
wolflet 1 Report post Posted June 8, 2010 i got my starmex inverter 28000 btu system 3 x 9000btu at 2930 with install. top up 120 for 1/2" insulation and a single split 24000btu mitsubishi non inverter at 1550 Share this post Link to post Share on other sites
wolflet 1 Report post Posted June 9, 2010 This is expensive. My air-con contractor ever quoted me starmex inv sys 3 (9000btu X 3) at $2800 include gst, installation & upgrade to 1/2 inch armaflex rubber. ouch Share this post Link to post Share on other sites
berry_surprise 0 Report post Posted June 10, 2010 (edited) and so i got a free inspection today at my place and was told sys-4: 3x10kbtu is good for all my 3 rooms (even including the slightly bigger MBR) and a 26kbtu is fine for my living as long i don't switch on all 4 units. i was also recommended either daikin/mitshubishi electric. so now is price war! ---updated--- pls tell me what do u think of this price? Mitshubishi Electric Sys-4 Equipment : $2,730.00 Installation : $1,110.00 Bracket : $150.00 GST (7%) : $279.30 Total : $4,269.30 including 2x10kbtu + 1x13kbtu +1x26kbtu Edited June 10, 2010 by berry_surprise Share this post Link to post Share on other sites
wolflet 1 Report post Posted June 10, 2010 and so i got a free inspection today at my place and was told sys-4: 3x10kbtu is good for all my 3 rooms (even including the slightly bigger MBR) and a 26kbtu is fine for my living as long i don't switch on all 4 units. i was also recommended either daikin/mitshubishi electric. so now is price war! ---updated--- pls tell me what do u think of this price? Mitshubishi Electric Sys-4 Equipment : $2,730.00 Installation : $1,110.00 Bracket : $150.00 GST (7%) : $279.30 Total : $4,269.30 including 2x10kbtu + 1x13kbtu +1x26kbtu inverter? whats the btu of the compressor? Share this post Link to post Share on other sites
berry_surprise 0 Report post Posted June 11, 2010 inverter? whats the btu of the compressor? Yes, sys4 inverter. Compressor is MXY-4A28VA, Capacity BTU/hr : 30366 Share this post Link to post Share on other sites
wolflet 1 Report post Posted June 12, 2010 Yes, sys4 inverter. Compressor is MXY-4A28VA, Capacity BTU/hr : 30366 from the looks of it, your blowers are way over the rated power output of the compressor. if 3 blowers are on at the same time, the house will not be cool enough. if all 4 are on, its almost impossible to cool. especially the living room. Share this post Link to post Share on other sites
berry_surprise 0 Report post Posted June 13, 2010 do u hv any idea whether aircon installer use copper pipe gauge 22 and drainage pipe 16mm?? is it better?? Share this post Link to post Share on other sites
clloud 0 Report post Posted June 15, 2010 Hi, need some advice here. Not sure of this is worth the buy. Quote from Hong Tar for Daikin non-inverter. Not getting an inverter cause of usage. Most of the time, only MBR on for a couple of hours at night. Daikin 20,000 BTU R22 multi split non-inverter aircon M/N: MA56/FT25 x 2/FT35 x 1 c/w ½ thick insulation (this is a 9000x2, 12000x1 configuration) Cost: $2,500.00 Note: Bedroom 2 & Study Room long piping estimated extra cost $300.00 To supply and install the air-conditioners in surface mount with standard one roll of G23 copper pipe not exceed 15m per fan coil unit, Class “O” thermaflex insulation for indoor unit and Class “1” black rubber insulation for outdoor unit, 16mm pvc pipe, pvc trunking, cable and stainless steel bracket. Two times installation. Equipment warranty: One year’s on spare part & five years’ on compressor from agent. Share this post Link to post Share on other sites
RenoEnthusiast 0 Report post Posted July 3, 2010 I am thinking of getting LG Health+ Sys 4 (3 9k + 1 18k btu) over the weekend at GC. Does anyone has any feedback on the LG Sys 4 and estimate pricing includes upgrades? Thanks Share this post Link to post Share on other sites
tz_jie 0 Report post Posted July 3, 2010 I am thinking of getting LG Health+ Sys 4 (3 9k + 1 18k btu) over the weekend at GC. Does anyone has any feedback on the LG Sys 4 and estimate pricing includes upgrades? Thanks Just bought the LG Heath Sys 3 (2x 9k + 1x 12k btu) from expo deco fair from AllBest after compare the price with GC. Upgrade the Compressor to 30k btu as the sales person from GC and AllBest recommeded cos the LG model that i purchase can be support system 4 with 1 compressor ONLY with the config ( 3x9k + 1x18k btu) in case i need it in the near future, i only need to purchase the additional blower will do. Share this post Link to post Share on other sites
demonlicious 0 Report post Posted January 13, 2011 Definitely Daikin Inveryter or Mitsu Elec Inverter. I'm using ME and my folks Daikin. Performace is good for both but Daikin fairs better in terms of low noise level. Share this post Link to post Share on other sites
