happiz 0 Report post Posted December 17, 2009 I really love the above pull-out type of kitchen tap. Problem 1: I have already drilled a 22mm hole on my sink, but most of these tapes are mixers and require a 32mm hole to install. The shop advice against redrilling the hole cos worried will dent my Reginox sink! Does anyone here know of anywhere selling a non-mixer version?? HELP!! Problem 2: My hubby is quite against it. He is worried about water backflowing and damaging the cabinet underneath. His arguement is that if it is so good, why no China replica. Can some users please share their comments & feedback on using such pull-out taps? Thanks in advance. Share this post Link to post Share on other sites
happiz 0 Report post Posted December 18, 2009 Anyone out there who can advise me??? Share this post Link to post Share on other sites
rummi 0 Report post Posted December 18, 2009 We are using a pull-out-tap too. The tap fits into any pre-cut hole of stainless steel sinks- no need to re-cut. You can go look at them (various designs) at Sim Siang Choon Share this post Link to post Share on other sites
happiz 0 Report post Posted December 20, 2009 We are using a pull-out-tap too. The tap fits into any pre-cut hole of stainless steel sinks- no need to re-cut. You can go look at them (various designs) at Sim Siang Choon Thanks. I'll check them out. Share this post Link to post Share on other sites
