alexter

Now the angry part. !! will not repeat the story. so just see the photos. drilling of the hole in the ceiling. the 4 nuts into the ceiling. too far apart by 1cm. after some bending on the bracket. it's mountingl time. don't know why still 1 bracket cannot fit. here he try to hit the bracket in place.

let see the cutting of the metal false ceiling. nice spark, hehehe ok finally a cut through. Got him a sunglass for protection, look cooler and cut faster... And yes we got a hole.

here the guy installing the hose by the toilet bowl for both toilets. here is the shower rack same for both toilets. And towel rack in the common toilet.

Here is my Alter Table. most likely it will beside the sofa and facing the window. The fridge and the yet to install kitchen cabinet. Bought the pillows and bedsheets. gingko pillow

Done with the lightings. yesterday the delivery of the dinning set, sofa, alter and fridge. Guys from the star furniture group. Here is the dinning table top. yea i got a table. Finally i got place to put my stuff. My Sofa still in wrap.

well i think 60" is the longest for ceiling fan. this shop in Boon Lay shopping centre. yes cheaper. so far the IMM one is selling cheaper then Hong Liang and my side. (surprise) there are a few shops selling heater, sink,tap,hob ect. but this small shop only sell heater and fan. at 3rd floor at the corner, between the carpark entrance and the lift. 707 compact $160. go check it out for other brand and model.

the boxes of the lights. My 3 bedrooms, 2 toilet and SSH using the same design lights. (different colour and size only) Price: $340 with installation. Model: AFH-141 (Empire) Blade: 56" warranty: 1 yr

Here is the Empire Fan installing of the fan this is the fan in motion. Here are the 3 lighting from the door entrance view.

camera, lights, action! the unboxing of the lights. kitchen light. the entrance foyer light. lights on, for the dinning area, entrance area and shoe rack area. Mid living room lighting. with 3 tube of lights and I/C unit to control either 1,2 or 3 tube on.

well their price not that good for the 707. the compact $230 and protek $278 (with installation) you can try Hong Liang or maximum credit. but i think Cheaper at the IMM 3rd floor at the corner, between the carpark entrance and the lift.

Today some of my purchase delivered. Dining table set from Zen Tradition Living Coin Rx Dining Table & Palazzo Dining Chair Sofa set from MONDI Lifestyle Uzzano Refrigerator from Mitsubishi MR-CU46T All of those still in wrap. As the photos in my laptop and i yet to upload them, hence will be up tomorrow. My lights are done today. and a major work....finally the heater is up. a few hiccup here and there. not easy to cut the hole, and took about 30min by my contractor. the heater installer was 1hr late, and they made some boo boo. Ask him to measure properly to drill the holes. young guys wanted to do a fast job, end up drill to far apart. spend 40min trying to solve this problem. lucky i got creative solution for them. then still want to a fast job, when mounting it up in the ceiling... only manage to bot up 3 nuts. they spend another 20min trying to solve the problem, hammer at the bracket trying to make it fit in. they so happy when i tell them just leave it... with 3 nuts, as it strong enough to hold the small 15L tank. problem 3... ask they to test which is the cold and hot pipes. they say standard one left is for hot water and right one is for cold. then after they install the cold water pipe into the heater, they on the tap to test... well you guess it.... wrong pipe. hence have to redo the piping into the heater. next problem 4. after installed and tested all the piping correctly, its time to wire it up. Simple right? 3 colour wires in the connector. i have to teach them how to hide the wires. (fair enough as they are not electrician hence don't know how and where the wires are above the fales ceiling) but then they took 20min just to figure how the wires join the connector and screw them in. i took 20sec look and tell them how and where to put the wires. then 10 min still not done, because they separate the 3 wires too short. i have to tell them to make the 3 wires longer which will be easier to put in. and its done in 3mins. On the heater to test.... perfect, it works. well is that the end? what else can go wrong? after the test, he has to close back the wiring case.... he break one of the case screw thread. now only can screw in one screw. one simple mounting only took them 3hr 30min. more story with photo tomorrow. !!

hmm sad to heard that. must blame the HDB for not having any sticker indication of the piping. even from the water piping drawing they only show how the pipes run, and did not show where are the vertical pipes.

OK i'm going over to wait for the delivery of all the stuffs. photo will be up very soon.

The Citigas guy took 10min to install the gas pipe in the morning. My kitchen carpentery was up yesterday. the right side is for my washer cum dryer and oven. here is my drawers and hob area. And the solid surface top guys were here last night to do the measurement. No light yet, hence touch light is the way to go. they were fast... 20 min by staple the frame to get the layout for the top.

ok i will have the lights up on SAT. the heater will be up on SAT. my sofa, dinning set, fridge and Alter table coming on SAT. will have a busy SAT, those who want to come see see are welcome. Sunday the painters will come to paint and touch up.

well below is what she be doing. up to you where to put the TV, on the 'new wall' or the 'feature wall'. just some rewiring will not reduce the reception.

Here i took some photo of the piping above the false ceiling in the toilet. As you all can see behind the tiles are only the same metal plate as the fales ceiling. The height clearance inside is about 25cm, cannot hide the heater there.

My contractor buy for me. i ask him to mount it on a piece of acrylic then mount on the window. he charge me $200 each with installation.

Here are my 2 Ventilating Fan. My 2 top windows panel are removed.

Wow! Nice! Your 3D look Zen style. Expensive? So the dinning set buying or carpentry?

Got photo to see? you got the 15L or 25L. just a note, you can use the bot and nut to hold the tank. i will get the 15L Joven one, and will cut a 30cm by 40 cm hole and ceiling mount it. then will do a small L-box to cover it. Hope the result is look good. don't mind me saying... Both your common bath area looks small, would be interesting to see how & where the 30L tank and the rainshower be.

Here were the carpentry outside my house, along the corridor. The Base of the Wardrobes This is the beijing bamboo lamination chosen for BR 2&3. here you can see the wall plastering not straight. "premium flat" This is the black lamination for the MBR.

well soon... hehehe i also waiting for your heater photo. i called Hong Liang about the storage heater (15L Joven and Ariston), realized now all selling the 3KW (Heating Element Wattage) and not 1.5KW. i guess i will get the Joven one as it can ceiling mount. i will cut a hole on the false ceiling in the toilet. Hope it can be done.

Really love the bathtub.. Now I wish have bathtub too, idea idea..... now i notice Jalan Membina can have hot water in the kitchen... the JW st64 don't have.

My Wardrobes are here today. the 3 rooms' will be done today. will post photo soon.