70wood

lol it's DIY slimfit

Dear all, the $10/- per piece special offer has expired on 15th July 2011. check out http://70wood.blogspot.com for other offers

First thing to determine, is probably the need for a workshop where it may have to accommodate all kinds diy interests, ie woodwork, metal-work, or arts & crafts etc. What would be the scale of the workshop, and the equipment & tools to include? Where could the workshop be, practically & geographically? If it's a workshop that simply consist of hand-tools and normal hand-held equipment, then it could probably take off easier. But if equipment that may be considered dangerous for an untrained hand, then the owner of the premises would be concern with safety and indemnity. http://70wood.blogspot.com

How is the DIY Club thing going? To get the idea off the board, it probably needs more than exchanging notes over forum. First thing is to keep this thread alive. http://70wood.blogspot.com

www.sgmobilemedia.com has some good ideas about children playroom. http://70wood.blogspot.com

If it's not too late, 70wood deck tiles is only $10 per pc for 30cm x 30cm with only a little left. http://70wood.blogspot.com

The rough cast you are talking about is to apply cement sand screed onto a plywood surface as if it is applying on any other wall. It is not quite feasible to have this effect factory done, and carted to be installed because the thin screed will give way in transit. Contractors would also prefer to do it on site, given some care and good housekeeping. This was done in the reception hall and the building frontage of Egg Story Creative Production in Middle Rd, which is now being occupied by Informatics. There are some issues with this, that is when extensive moisture gets in between, it will show up prominently on the surface of the rough cast. Also the plywood used needs to be in compliance to fire safety standard. http://70wood.blogspot.com

Yiap Hing Cheong (Balestier Rd & MacPherson), & Homely Hardware (Ubi Ave 1 & Serangoon Nth Ave 5). Both are authorised dealers and stockists for Makita products. They also carry cheaper brands for non-industrial users. http://70wood.blogspot.com

hi you can try Wen Tat Hardware at Hougang Ave 1. You can check out their number from yellow pages, call first before going down. They have a wide range of profiles and can deliver if the volume is big. http://70wood.blogspot.com

There are many reasons why water gets pass the roof into the rooms. The tiles could be cracked or broken. If this is the case, then it is possible that the entire roof needs changing on the assumption that all the tiles are of the same age. Roof tiles are generally quite hardy unless they are old, say over thirty years. Another reason for broken tiles could be TV antenna man damaged a part of the roof. Cheap way is to apply a lump of cement over the damaged area, or change the affected tiles. Other reasons could be choked gutters that force the rain water to flow backward, then clear the gutters. It could also be that the flashings and cappings, metal plates that overlap the end part of the roof, could be rusted allowing rain to seep through. Sometimes the roof is perfectly fine, but just that the heavy rain happens to blow towards a certain direction that instead of the rail flowing downwards, it goes upwards and seep through the joints between tiles. If this happens, no contractor can help. But here again, you did not mention what type of roof your landed house is having, so it is only an assumption that it has French clay roof. http://70wood.blogspot.com

This newly released 90cm x 45cm ready to use deck panel suits the use in many apartment balcony/planters. Using 70wood profiles, it neither attracts termites nor decay over long period of weathering. http://70wood.blogspot.com

Hi Hongpl, DIY tiles are kind of flexible (not rigid) hence it is not suitable to hold any weight. Should you need to cover, you will need to have one fabricated to size.

Simple and lively....nice

Hi, I suspect the problem had emerged due to the decking contractor drilling into the tiles of the balcony that may have punctured the waterproofing membrane, if any. Here again I am just guessing as I do not know if this is really the case. I am also wondering if the deck you built had sufficient ventilation gaps between panels so that moisture can escape instead of being trapped. Once a hole is created in the slabs, water above the membrane will find its way from all corners, and spreads to the entire slab below the membrane. If this happens, the way to go about is to remove the deck, seal the entire tiled are with a new membrane or a reliable chemical, creating a new tank above the tiles, and put back your deck without drilling into the floor again. Another way, which sounds rather ridiculous is to seal up at the entire deck leaving only a drainage hole where water can be drained into the gully hole. My two cents.

Right now 70wood DIY Deck tiles are on warehouse sale (self collect), at only S$10/- per piece. Base on your 2.4m x 1.6m or 7.8ft (8ft) x 5.2 (6ft), you will need 48 pieces of the DIY Deck Tiles.

I'm sorry that you are placed in this most unfortunate situation. There seems to be no other option for you than to approach your TC & MP, though some forumers may have other advice. Talking to your neighbour nicely is good, but first and foremost they must be very understanding people to be able to listen you out, but what they have already done show otherwise. Playing the "rights" card, that your neighbour is causing a fire hazard will not augur well with the TC & MP. Only way is to play the victim and plead with them to understand how your neighbour has cause you such terrible discomfort. If you do not like to call on the TC or MP, Take pictures of your corridor and email them to the TC and MP. If that does not help, then forward the same email to the National Development minister, and perhaps later the Prime Minister. This will make the TC and MP wake up if they didn't do the job well. http://70wood.blogspot.com http://70woodprofiles.blogspot.com

Will your neighbour allow you to take pictures of the leakage? It will help by posting the pictures here. If your house is HDB then it's a lot easier to solve. If not, then we have to determine whether it's a multi-storey apartment, or a shophouse with upper floor residence etc. Types of housing can pose unique leaking problem where the source can come from leaking pipes, damaged cappings at the roof, punctured water-proofing membrane etc. Until you determine the source of the leak, there's no solution to it. http://70wood.blogspot.com http://70woodprofiles.blogspot.com

It is very interesting that you are able to rent out an unrenovated roof. You probably has an attic, and could also have an open-air rc flat roof. I remember the Mountbatten CC has a roof garden whereby its members chill-out, and particularly during nights where there are fireworks from the stadium as well as the esplanade area, it's really cool. The Kembangan CC also has one, but lack the height for a good view. Attics can be very hot even if with insulation, and air-conditioning load can be very high. But attics and roof gardens are very cosy place, like you say to chill-out or to spend some quiet moments alone staring at the sky. Older houses do not have waterproofing membranes underneath the screed of the rc flat roof, but the newer ones usually do. So drilling into the roof can damage the waterproofing membrane and void the gauranteed that comes from the manufacturer and installer. If the roof is very old, likely is that is is very course and putting a coat of screed with sika will strengthen the waterproofing. For flooring, you can use 70wood's DIY deck tiles, and you don't really have to tile the entire space, but only the essential areas where traffic is likely to happen. The rest of the areas can be creatively treated with box plants or pebbles, or even box grass to give it feel of nature. 70wood also sells materials where one can build your own trellis, planter boxes or even build your own decking. Before putting up your BBQ pit, maybe you want to know if your neighbours are hanging their laundry overnight. Surely you won't want them to wake up the next morning having your laundry fragrance being replaced with a totally different kind of aroma. http://70woodprofiles.blogspot.com http://70wood.blogspot.com

There's a guy in Ang Mo Kio who used to own a "Sunlight Awning Co" and now sort of retired. If you can take a picture of the window for which you intend to install the awning, email to me at diy70wood@yahoo.com, and I can pass it on to him to give you a quote. Cheers

I guess you are referring to the metal frame that holds the awning, and not the brackets per se. That has to be fabricated, whether with wood, or metal. The choice of which also depends on what material you use to cover the frame making it an awning. There are aluminium awnings where you customize order the aluminium interlocking strips, and this strips are hled together by slotting into each other. Other alternatives are canvas, polycorbonate sheets, corrugated sheets etc. Cheers, http://70wood.blogspot.com

Hi Sujuan, Accordingly, there are two issues at hand. First, you find the sound too loud, and next is the echo. Let's tackle the echo first. I am imagining that the room is pretty empty except for the piano. Hard walls repels sound, particularly in a small rood (EM room on lower level is smaller). Furnishing deflects and/or absorbs sound, and if it's an empty room, a DIY solution is to curtain up the walls with thick materials. Others include sponge wall, carpet wall and the list can go on. You did not wuite elaborate the loudness issue, as to from where or which part of the house that you find the sound of the piano room loud? If it is from the upper room where it could possibly be your MBR, then it is a structural sound transmission problem. What you can also do to eliminate structural sound transmission is to isolate the sound source from the building structure, that is perhaps have a floating floor, supended with joist, or at least a suspended platform for the piano so that the vibration from the piano will be absorbed by the suspended platform. I hope it helps you. http://70wood.blogspot.com

Dear Tim Kendall, 70wood DIY deck tiles comes in matt dark wood colour and needs no lacquering. It is an ideal colour for outdoor, and you do not need to re-colour or oil it again. I hope that answers your question, but if it does'nt, please email me via infos given at http://70wood.blogspot.com. Best wishes 70wood

70wood has DIY Inter-Locking Deck Tiles that are 100% weather proof. Having a warehouse sale now at $10 per piece, usual price is $23. Check out at http://70wood.blogspot.com

70wood has this product. It is having a Warehouse Sale on it's DIY Inter-Locking Deck Tile. 30cm sq, 1.3kg each. Usual Price $23. Now $10 per piece limited to 550 pieces. http://70wood.blogspot.com