icemochi

Just to share another lesson.. The wood is 50mm thick .. so can only add wood trimming. cannot use the better abs trimming. dunno why they give me such a thick top but the drawer top is paper thin.

my table is 1.5mx 0.8m; definitely small enough; the ID himself says its due to laminate OOS and they didnt give me a choice to choose another laminate. this is the edge .. jagged but claimed to be "chamfer" trimmed? i ask for all corners to be round so my kids wun accidentally get hurt .. but 2 of the corners looks like this: Must all requests be made specifically to the contractor? like 1 laminate, no sharp edges and emphasis all round corners?

Can do that? Sounds good now u mention .. I only ask him to trim the edge; actually the table is a joke .. asked for all corners to be round and somehow only end up 1 round corner. Most consumers are very amateurs and always kana eaten .. must move a few time hse before can get used to their "industrial practices" i havent accept it. Now when he's free, he will come kajiao me.

OOS out of stock. Your ID is not my one. But do tell them u want a single laminate for the table top. that's common sense or so i thought.

i also got gain city to install hitachi sys 4 5 mths ago. Also gas leak! Thought they are supposedly the best in this line but also KNS.

My first time doing renovation and I requested to do a study table. The laminate went OOS and the carpenter used a few pieces to overlay the table top. The bottom he used another inferior laminate. The edges of the table not smooth out; its sharp and can cut into your skin when you rest your wrists on it and the contractor insist this is market practice. Quote him :"No one will rest their arms on the table edge" Correct me if I'm wrong .. who will custom make a $1500 table that you cant rest your arms on the edge for? Not only the table, I entrusted them a working toilet and they give me back a leaking one after the renov and insist the old internal pipes burst; not their fault plus a whole array of renov cut-corners.