pally78

' 1 round of polishing has been done and as far as i can tell. The grout lines are hard.Its just that our marble floor has alot of lines running around. Hopefully less visiable after polish.

My parents place and my wife's parents place has marble flooring also. We kinda have expectations on how thin or thick those lines are. The issue now is..we arent sure if its material problem or workmanship problem. If its material problem then no point getting the same type of slabs to replace. If its workmanship problem....then the ID better not use the same person to lay the tiles!

I just bought a resale flat and had decided to use marble for the flooring. I even did a pre lay to ensure that the marble are defect free. However, when my ID completed the laying, i was throughly dissapointed. My wife and i decided on marble because the lines between the tiles are very fine and there would be minimal gap between the tiles. However, we were shocked when we found that were huge gaps between the tiles. My ID say its because the marble slabs were of slightly different sizes and hence they couldnt really lay it close. I have measured a few tiles and found that there was a slight difference of 1-2mm between the times. My issue here is....is this a case of bad workmanship or lousy materials? Any advise what can be done to fix this issue?

I am looking for a realiable contractor that delivers on time and has high quality work man ship. The 3 contractors i have short listed in beauty world are : 1)la belle building and contract 2)Hai San design 3)Urban design PM me if review is negative.